LED neon installation guide
How to install your LED neon sign
Mount your acrylic-backed LED neon sign using the supplied fixings, then connect the low-voltage power supply.
What you’ll need
Pencil and tape measure
Spirit level
Drill and suitable drill bit
Screwdriver
What’s supplied
LED neon sign
Chrome wall fixings
Low-voltage power supply
Dimmer, where included
Choose a position within reach of a socket. Check that the cable route will be tidy and that the wall is clear of hidden pipes and cables.
Step by step
Install your sign
Choose the position
Hold the sign against the wall and check its height, alignment and access to the power socket.
Mark the fixing points
Use a pencil to mark through every pre-drilled hole. Check the marks with a spirit level before drilling.
Drill the wall
Check for hidden pipes and cables, then drill each mark using a bit suitable for the wall. Insert appropriate wall plugs.
Mount the sign
Fit the supplied stand-off fixings through the acrylic. Tighten until secure without placing excessive pressure on the backing.
Connect and test
Connect the low-voltage cable and dimmer, where supplied. Plug in the power supply and test the sign.
Important: Use fixings suitable for your wall. Do not overtighten fixings against the acrylic backing and do not switch on the sign until every connection is secure.
Common questions
Need to check something?
Can I use adhesive strips instead?
Only use an alternative fixing method if it is rated for the combined sign weight and your wall surface. Little Rae cannot confirm the suitability of third-party adhesive products.
Why will my sign not switch on?
Check each low-voltage connector is fully inserted, the dimmer battery tab has been removed where applicable, and the wall socket works. Contact us if it still does not illuminate.
Installation support
Still need a hand?
Send us a photo of your sign, fixings and wall and we’ll point you in the right direction.